Alternative Paintball homepage
 

Paint Cannon Parts and accessories

The following items are used to construct your own cannon.  When you  construct your own custom cannon, these are the types of parts you often need. 

Remote Setup

Increase the range, ease of use and reduce the weight of your cannon by going remote and placing the constant air bottle on your harness.  Includes quick disconnect.  

Dual Valve Piece Adapter 

This special fitting attaches to your paintguns C/A fitting and enables you to screw your co2 supply onto it just like normally.  In addition, the side of the adapter has a 1/8" female NPT that will enable you to attach a co2 supply line to another device such as a cannon or another co2 tank.   The adapter includes a brass plug to close the 1/8" hole when not in use and o-ring.  This is the same adapter to use when building a paintball cannon that requires C/A threads.

12 gram CO2 Cartridges 

Used with the 12 gram quick change adapter to charge your paintgun or cannon with co2.(pack of 6)

12gram Quick Change Adapter

Can screw into the constant air threads of your paintgun or used to construct your own custom cannon. 

3" Water Balloons (100 count) - Biodegradable

Used to make the water balloon rounds for use in 2" paint cannons.

Water Balloon Filler system - Fill your water balloons from any water source

Webbing Gun Sling - Green canvas adjustable gun sling with snap hooks on each end.  Can be attached to your paintgun or cannon.

1200psi Micro Gauge - Small gauge that screws into any 1/8" threads (dual valve adapter) to measure the tank pressure of your paintgun or cannon.  Small and durable.  Measures from 0-1200 psi.   Optimum gauge for co2 or compressed air.

Other Items used for custom cannons:  These parts are used to construct your own cannon or customize the gas feeds for your paintgun.